多年前買『3D打印機』感温頭失靈,整左幾次都係咁,唯有買過臺新機,睇蒞睇去買『DDKUN-T3040』.
冇左『SD卡』同『USB連線』得翻『USB磁碟』同『WIFI連線』,通過WIFI連線登入後臺.即可上傅『.gcode』檔,并指令打印.吾使行蒞行去.再通過摄錄機實時𥄫實.
厰商推薦『Simplify3D』比『Cura』复雜. 載入STL檔, 要符合ASCII碼, 即係『字母A~Z』『數字0~9』.
『XY軸直線导軌』加『閉環伺服電機』,比舊果臺靜幾倍,訓覺覺豬都噪吾到.
贈送『WIFI天線』驚踢踢攔. 换『蘑菇頭天線』.
平臺鋁板加厚, 熱床加熱100度起碼伍分鐘. 建議90度. 否則會因熱床升溫過慢, 導致FIRMWARE SHUTDOWN
| Heater heater_bed not heating at expected rate See the ‘verify_heater’ section in docs/Config_Reference.md for the parameters that control this check.Once the underlying issue is corrected, use the “FIRMWARE_RESTART” command to reset the firmware, reload the config, and restart the host software. Printer is shutdown |
『平臺90度』+『冷卻風扇0』+『鋼板』+『薄膠水』打印『ABS』. 即可『加熱吸附』『降温剝離』.底坐係『波浪紋』吸附剝離相而.
指南書建議冷卻風扇轉速100滿速運轉, 實測會令熱床降溫導至脫落.
平臺有摄像頭選項,實際際冇內置摄像頭. 『触摸板』有『micro-usb』, 槓底有『USB-A』.